Who wants a Kiwi?

[Chris]

nice job, where did you find the molex connector for the ide power? I've been unable to source one.

[linux68k]

Jameco has them, I think this is what you are looking for
JS-1114-04WS-R

[SteveMoody]

I got mine from rapid onilne

http://www.rapidonline.com/Cables-Conne ... er-22-2920

[Chris]

thanks guys

[simon]

Pretty busy pre-soldering the SMT parts of the upcoming Kiwi kit...

[linux68k]

Hi Simon

Do you have a cost for the kits?

[simon]

It will be around 350€ + PSU (25€) + 4MB SIMM (10€) + shipping (depends on where you live).
You'll get the board (with SMT parts pre-soldered) and every other parts, but the SIDs. If you don't have the original 6581 or 8580 you can get one or two SwinSIDs for another 15€ each. The Atmega, Eprom and CPLD will come pre-programmed with a working version of the firmware(s). In addition I will offer a CF card (9€), CF-IDE adapter (2€) and the needed power cable + adapter (2,50€).
What I can't offer are a keyboard, a mouse or an enclosure (case).

[msch]

I want one - too (complete kit)

[linux68k]

Hi Simon

Do you have any bare boards and what is the cost?

Thanks Tony

[simon]

Hi Tony,

the boards of the last batch run are presoldered already, but I still have a spare bare board from the previous run. This would cost 75€ plus shipping.
There is one presoldered board where two databus pins of the cs8900a show infinite resistance. That never happened before and I don't want to sell it with a kit. If you want to try (and maybe have to remove the CS8900a) you can have it for 90€ plus shipping. Otherwise I would keep it and eventually build it myself.

Best
Simon